CMC Drop in Trigger + AR-9?

Warscorp9

I apologize if a similar question has been asked, I searched around and I was not able to find an answer. I have a Wraithworks Warscorp9 scorpion mag fed AR-9 that I am running a Maxim roller delayed buffer and CMC single stage cassette style trigger in. Does anyone know if it is possible to modify this type of trigger to be compatible with a super safety? Any help is greatly appreciated, thank you.

undeadchew

Warscorp9 Yes I have cut CMC triggers before, remove .75mm from the back of the tail, make the left side of the tail 1.5mm thick, and then round the corner.

Warscorp9

Thank you very much. Is there any other modifications you made? Also, are you able to reply with/post pictures? I am new to this forum, so not sure if that is possible or not.

undeadchew

Warscorp9 yes I posted a picture but my server is down the moment you checked. And other than what I already told you, you just need clearance on the right side from the cam.

Also you may need to tune the lever to alleviate bolt binding, and modify your 9mm bolt weight if it protrudes into the cavity where the lever is supposed to be.

Warscorp9

Okay, thank you. Did you put the picture on this thread, or somewhere else? Because I am still not seeing it on this thread. Because I am running the Maxim roller delayed buffer, I have my bolt weight removed already. From what I am aware, that coupled with the risk of OOB detonations being pretty much negated by the roller delayed system makes it a good setup for a super safety.

undeadchew

Warscorp9 Yeah it's in this thread I just had to restart my server.

Warscorp9

Awesome, thank you again. I’ll be sure to post any further questions I might have.