I am having issues getting this super safety to function. I installed a full auto bolt and a heavy buffer system. I also shaved down the trigger and part of the upper receiver. While holding down the trigger the super safety functions and resets the trigger every time i pull the charging handle back in super safe mode. But when i actually shoot the gun in super safe mode it will fire one shot then the trigger gets stuck. I don't know where to go from here
Super safety problems
When you say the trigger is stuck, what does that mean? Is the hammer in the fallen position when this happens? If so, the hammer would block the trigger from moving forward manually, making it appear stuck.
The cause for this is hammer follow, that is the trigger is unlocked by the cam too soon, allowing the hammer to fall on an unlocked bolt.
hoffmantactical yes the hammer is in the fallen position so that seems to be the case. But it shoots just fine in semi-auto mode, it seems to only do the hammer follow in super safe mode. What would be a fix for this?
You have to slowly go over the entire cycle and find why the trigger is unlocking too soon. Could be an over ground trigger tail, or a loose lever.
a month later
I just installed a new precut trigger, cam, and lever and have the same issue. Semi auto is fine. If the hammer is being released too soon, should the lever “tail” (part that touches the bolt) be shaved to help delay rotation of the cam and not release the hammer early?
Do you guys recommend a specific spring and buffer weight as well? Im running stock spring and a slightly heavier buffer weight.
Buffer weight should have little effect.