Group Project Help

hoffmantactical

Tacticalrun_556 Bambu or Prusa for the printer. For filament I'd always start with PLA Pro for the first few prints just to learn the ropes.

Thunder3

hoffmantactical I sent you an email before I found this forum. What about the new creality k2? Or Bambu all the way?

I say this for the heated enclosure and being able to use easy type of filament out of the box

I_Dont_Wanna

I was wondering what I was doing wrong with my super safety it works great in semi auto but when I drop it in the middle for full semi, the trigger pull is really stiff and sometimes I have to pull it twice to get it to go once I get it started. It seems to work fine but that initial pull it’s like Really hard

Codydail

Does anyone know why my supports are stuck to my prints i just updated some of my cura setting and now i don’t remember what i had them set to

Codydail

Also im having little droplet build up on the edges of my prints

marriedwchildren256

If you can't remember probably good to just run through ellis tuning guide again .

hoffmantactical

Thunder3 I don't know much about it, but if there are no glaring issues the K1 is probably good.

Thunder3

hoffmantactical went with the Bambu

Rusty_sheckleford

RustyShackleford fancy seeing you here

Rusty_sheckleford

Rusty_sheckleford as is with you good sir

PistollPeet

Looking for help troubleshooting a g17 build. Don’t know where to start. Having ftf/fte issues as well as the recoil spring and guide rod keep going out of alignment. Not sure if it’s just cheap parts issue, the mag, the frame or something else. Unfortunately I have only taken it out once so I haven’t had a chance to try another mag yet.

hoffmantactical

PistollPeet Failure to eject is really common with Glock builds. Failure to fire less so, but probably caused by the slide sitting out of battery. Could you share any photos of the spring alignment issue?

« Previous Page