SiiiNeR New to 3d printing and ran out of filament 70% into orca lower. Have filament coming tomorrow should I keep print paused or scrap it and start over? Printer is creality k1 max Using esun pla plus
hoffmantactical Keep it running. Worst case you can restart if there is an issue after you change the filament.
SiiiNeR PistollPeet didn't have the modifier set correctly. Just got new one off printer and it came out perfect
PistollPeet hoffmantactical Am I seeing things wrong? It looks like gaps in the filament lines near the bottom of the picture.
hoffmantactical PistollPeet That is correct, a common artifact on infill. It's due to the flow rate changing near the ends of the lines. Pressure Advance can help, as does printing slow.
