spacecase544 Been looking at a couple of different filaments to try, anyone tried a PCTG or another one called PolyHex? PolyHex looks to be about 10% low on tensile strength, and the PCTG comes in low as well for ultimare tensile strength. I'll be glad to give them a shot. I know the PCTG prints very nicely and is a great strength improvement over PETG. PCTG TDS: https://cdn.shopify.com/s/files/1/0027/5339/6848/files/TDS-Essentium-PCTG.pdf?v=1723400619 PolyHex info: https://www.ic3dprinters.com/ic3d/wp-content/uploads/2023/07/PolyHex-Quick-Facts.pdf
hoffmantactical Polyhex was recommended to be on X by someone who uses it one quad parts. But don't know much about it. My testing with Fiberlogy PCTG showed that it still had some of the impact resistance issues of PETG, just less often.
spacecase544 hoffmantactical I'll be glad to give it a run and see what the results are and report back. May be a little slow going since I don't have open access to anything other than indoor commercial ranges, but I'll do what I can.
