Hey guys, fully assembled the orca and am having some issues with getting rounds to chamber.
Sometimes when charging the gun, the round will just not be loaded and it can happen several times in a row. Sometimes a round can also partially come in but obviously jams and becomes very hard to get out.
There is also an issue however of 2 rounds trying to enter at the same time, with one getting jammed far into the chamber and another trying to feed in behind it.
I have only managed to fire 1 round out of it so far, the casing successfully ejected but then i believe there was a double feed after that i had to clear by taking the magazine out and tilting the rifle back to get the first round to fall out from further in the chamber.
All of this was through about 5 tries to fire the gun but i was using live ammunition at a range so i didn’t want to start fooling around with it more there. I might print some dummy ammo and see whats happening. I was also using a PSA P-mag during this with some brass range ammo.
Any ideas of something that may have gone wrong in assembly, or do i need to sand something down or redo a print somewhere?
