Bambu A1 HELP!!

BallisticBrax

Trying to print sl-15. Don’t really know what the issue is? I’ve cleaned my plate and did calibration after calibration. 5 attempts have been failures. I’ve read it could be contact and I’ve tried fixing the issue in slicer but idk if I’m doing what is right for it to print correctly. Please Tim, drop your wisdom🙏

undeadchew

BallisticBrax I'm guessing you mean to say your prints are lifting up off the bed?

If that's the case, when I am using a bambulab textured PEI plate, and experience such issue I will use a glue stick on the bed in the area where the lifting occured.

Sorry I'm not Tim, but I am here to help if you would like.

BallisticBrax

undeadchew thank you for this I will try this. Little more info, the prints either lift or start to spaghetti? Idk if that means it’s something else but I will try my best.🙏🫡

undeadchew

BallisticBrax Sometimes bed adhesion gets worse with wear being printing, and pulling off a print in that spot, to get around this you could try moving the print to a different spot, change rotation, add a brim. What filament and settings are you using?

Have you printed a benchy or any other parts yet?