3d-Printed LimaSix Lower WIP

undeadchew

I was wondering if a right sided ribbed SL15 lower would fit on the limasix upper?

hoffmantactical

Nice work! The rib on the right may be a little long for his handle though.

very smart BTW, cutting and flipping the rear only. Working with bodies is so powerful.

My plan is to print the front on the side, and bolt it onto the rear. Will also turn the plates to run for and aft above the dovetail, to allow the belt sack to sit as high as possible.

undeadchew

hoffmantactical Hey thanks this is the result of being as lazy as possible.

I do see how far back to the rear the charging handle comes now, I'm not sure if your double rib design will fit there either, which was my next go to.

Also I am thinking maybe we need to use our own charging handle design that brings the handle forward a bit in order to have space for a rib that will provide maximum reinforcement possible. Or maybe the handle can be flipped 180 degrees?

Also I can't wait to see what design you come up with it's bound to help democratize belt feds for everyone.

And here's my attempt at an exit hole just in case.