Hi guys! I'm having some bad luck with the slide lock functioning on a Chairmanwon Biggus Dickus dd19.2 printed out of Polymaker Pla Pro with 10 walls, 100% infill, 220⁰/55⁰, Sunshine Rails and LPK from MAF, and a Dagger slide because I spent my Glock money on filament. It worked fine for a mag, and then only light strikes. I then swapped out the LPK for factory Glock, and it worked for another mag, then light strikes. If I hold the slide back ever so slightly, I get a full primer strike and the round fires. It looks like the slide lock hole is too large, or if I had a thicker slide release it would work. Can anyone please advise on what I should do? The first picture shows the slide lock resting in the upper rear of the too-large cavity, and the second shows it being pushed too far forward to allow full primer strikes.

