How do I in r ase rate of fire

-MurphyToadster200x

On an 11.5 I have an H2 buffer and it honestly cycles slow. Will a carbine buffer increase the rate?

patriotpa

-MurphyToadster200x I like a slower, more controllable ROF, like the M3A1, say 450-550 rpm. Much more practical than a 2000 rpm zipper.

-MurphyToadster200x

patriotpa I think... I just kinda think... That it's because my buffer tube still has the stock buffer and spring because I never thought I would need the fixed buffer block. Because right before I gave up I got one lucky 3 round burst, and the rate of fire was beautifully psychotic fast. So I'm gonna tinker on a way to stabilize that bolt assembly

patriotpa

lower mass-higher RPM, but beware of bolt bounce.

hoffmantactical

patriotpa I'll admit, I have to disagree. But each does have its own application!

patriotpa

hoffmantactical Ex-Army. Conservation of fire. You can only carry so much ammo. Short controlled bursts unless you need to GTFO in a hurry, then dump and de-ass the AO.

-MurphyToadster200x

I don't care about weight of carrying ammo how expensive it is. I reload ammo I have a giant stockpile of components, and expendable income. I want my SS to shoot at least as fast as a Vietnam movie. It's currently shooting slower than my finger and it pisses me off. With the current setup minus the SS I could bump fire that so fricken fast. Why is it slow on SS. Is H2 with an 11.5" barrel too heavy?

undeadchew

-MurphyToadster200x Well if you said you could bump fire it fast in the same configuration, this leads me to believe that your super safety isn't tuned correctly and is causing friction in the system slowing everything down.
I would remove a little bit of material from the lever's surface highlighted in green below in my picture. Then polish and lubricate.

-MurphyToadster200x

undeadchew that same lower I'm complaining about also refuses to do operate with my 22 upper even though it has the bore buddy trip sled. It will shoot one round, load the next round but will have a dead hammer . And in semi it shoots fast and flawlessly. Maybe your right, because I'm starting to think that lever or something is causing resistance while on middle/SS mode. Thanks for all the help guys I appreciate it more than you know