Alright so finally got my printer in, opted for the kobra S1 combo. Now I'm trying to assemble a glock 43x. Ive gone through all the struggles of figuring out I needed rails and trigger lock block, to understand not all files use the same rails xD. I purchased dd43.1 rail assembly and 43x lower kit off ebay. Now, on certain frames my tension bar for the mag is too long so I had to find a frame that it worked with as is, done. Then I went in and installed my rear rails , and I assembled my trigger housing and such. Here is my next issue.
When I try to drop the trigger in, it simply doesnt drop in theres a part of the rail that prevents it from going in. Im not sure what im doing wrong but it is a bit frustrating currently using the bb 43x dragon design not because I like it but because the tension rod fit. If this isnt the place for this please advise and ill correct it. As a side note are there any other forums I can tap into to learn more about this craft?