Cracked buffer tower repair? Also epoxy question.

Slippery

Had my first ever SL-15 print fall off the bench and, sure enough, the buffer tower cracked a bit. I'm wondering if it could potentially be saved with epoxy, as the break was clean and will be reenforced regardless. Threading is fine too.

I'm wondering: Has anyone ever fixed this issue with epoxy or used epoxy to reenforce a non cracked build? Really want to save this print as it took ₂₄ hours to complete.

hoffmantactical

Was this without a hose clamp, at the layer lines? If so, epoxy should work fine. In fact, I've run lowers with a crack, the clamp holds them together.