SL-9 Mags dont fit

WaffleStomper

Printed out the SL-9 last night and had a few mags to test fit and noticed they just flat wont fit up in there. it doesnt fit from the front to the back

Can I file thee lower down I dont think its off much, or are they just cheap mags, which they are.

hoffmantactical

You can file to fit, as long as the other components fit fine it will be OK. This is probably due to a scaling error making the lower a bit too short.

gnilreib

I'm no expert on mags, but I can say that I printed out the 9 & 308. The mags I got for the 9 fit fine, the 308 required a lot of sanding/filing.

The 308 mag was this: https://www.bearcreekarsenal.com/amend2-7-62x51mm-sr-25-10-round-magazine.html

I also printed a 308 mag and that was super tight, tighter than the amend.

WaffleStomper

gnilreib
haha my mags were from classic arms clearance think I paid 9 or 10$ for a 33rd funstick... I was half tempted to hit up rural king to get a real glock mag..

I guess since I tossed it on the shelf been to busy, I should check out orca and get a measurement and measure what actually printed to see if it was a shrinkage problem.